Back to News main...

New LED curing pen is set to revolutionise UV curing

The COOLLED 2600 is a small, lightweight and inherently safe LED UV curing pen that uses COOLLED technology to produce bursts of high intensity, UV visible light capable of light curing products within seconds.

Measuring only 128mm long and 23mm in diameter, this highly portable unit weighs a mere 57g (less than two ounces) and will be ideal for adhesive bonding of glass, metals and plastic components and for applications such as wire tacking and component support.

The pen operates within a Class 1M safety classification because, with LEDs, only a single peak of energy is generated and the emission is strictly controlled to minimise the risk to eyes and skin. In addition, LEDs can be switched on and off instantly, no warm up period is required. The system is also mercury and ozone free and generates no heat from infra-red radiation.

Simplicity of use is the keynote. It is merely a question of applying the adhesive, lining up the components and pressing the start button. It can be operated in two modes: a fast five-second burst of full power or by gradual power increase for low stress curing. Each burst is followed by a 15 seconds lock-out period with the start button inhibited. This restricts the temperature rise of the LEDs, providing a life of over 10,000 hours, and ensures the operator is only exposed to safe levels of UV light and therefore requires no protective clothing or goggles.

The pen is normally mains operated but for applications in remote locations or where full mobility is required, an optional, rechargeable, belt-clip, battery pack is available. Battery life between charging, with maximum usage, is eight hours with a recharging time of four hours. The spectral output is 385-400nm with a primary peak of 395nm and power requirement is 110-240VAC, 50-60Hz. Typical output at source is 0.8W/cm2.

Back to News main...